Jaw style Mop Handle

The chuck of Jaw style Mop Handle is made of a tough one-piece material with fine anti-slip teeth on the inside, not the kind of plastic that is prone to deformation, the installation is particularly simple. Align the drag head with the slot in the middle of the chuck, and gently pull the control lever on the side, the chuck will firmly bite the drag head just like biting something, there is no need to tighten screws or wrap tape.

The Jaw style Mop Handle holds very firmly, the opening and closing Angle of the jaw clamp is large enough to fully "hold" the mop head. Unlike ordinary small clamps that only hold the edge, no matter how hard you push or rub against the side when mopping the floor, the mop head will not shake loose, nor will it suddenly fall off. The control lever is designed with just the right force. A girl can open and close it with a gentle pull without much effort, and it won't be too loose, causing the chuck to spring open by itself.

The durability of the handle is very reliable, the rod body is made of anti-bending material, so it won't bend or deform even when dragging heavy objects or hitting a corner of a wall, it is more durable than ordinary plastic handles. The anti-slip teeth of the chuck will not scratch the fabric of the drag head, and repeated clamping will not wear out the interface of the drag head, thus extending the service life of the drag head. There is also a thoughtful design. The control lever has clear "Open" and "close" labels, which the elderly can understand at a glance without having to repeatedly try and make mistakes.

Our Jaw style Mop Handle is more flexible than traditional mop handles, there is no need to change different handles for different mop heads. One can match various mop head accessories at home, the chuck is easy to clean. If it gets dusty or covered with hair, it can be wiped clean with a damp cloth. Unlike screw interfaces, it won't accumulate dust and be difficult to clean.

Product function

The Jaw style Mop Handle mainly helps to mop the floor with less effort by fixing the mop head, whether it is mopping the tiled floor in the living room or the wooden floor in the bedroom, after the jaw clamp firmly fixes the mop head, it can be pushed and pulled very stably. There is no need to hold the mop head while mopping to prevent it from shifting, after mopping the floor, the force is evenly distributed and there will be no blind spots that are missed. Don't worry if the drag head becomes heavy after absorbing enough water, the chuck has a strong load-bearing capacity and can firmly support the drag head without it falling down.

The effect is particularly obvious when changing the mop, after cleaning the oily mop in the kitchen, if you want to replace it with a clean one to wipe the bedroom, just pull the control lever to remove the old mop. Put the new mop in and tighten it. It only takes a few dozen seconds to finish, there's no need to look for a screwdriver for a long time or remove the clips and waste your nails.

The Jaw style Mop Handle can also be used as a temporary fixture occasionally. For example, when mopping the floor and there is no place to put the cleaning cloth beside it, stuff the cloth into the jaw chuck and hold it tightly, then it can be used as needed. Or when cleaning the bottom of the sofa, for areas that the mop can't reach, just insert a small cloth into it to wipe, it's much more convenient than using your hands directly.