Metal Mop Clip

The entire Metal Mop Clip manufactured by Rongfu factory has no sharp edges or corners, the edges are all ground very smoothly. You don't have to worry about scratching your hand when installing it, and it won't puncture the fabric when holding the drag head. To open the package, there's no need to look for additional tools, just insert the interface between the mop handle and the mop head, tighten the knob, and it's done, it only takes a few minutes.

Our Metal Mop Clip is sturdy and durable, the plastic mop clip will be stretched out by the mop head after a few months of use, or become brittle and break when stained with oil. This metal clip does not deform even when repeatedly picked up, even if used every day, it will be fine for one or two years. The load-bearing capacity of the alloy material is strong enough, after the drag head absorbs water and becomes heavy, the clamp can still firmly hold it, and it won't be as loose and saggy as a plastic clamp, when mopping the floor, the drag head will sway along with the handle.

The anti-rust treatment is particularly thorough, you can use it with complete peace of mind in damp places like bathrooms and kitchens. Unlike ordinary iron clips, it won't rust and flake off after a few uses, leaving the mop head dirty. It's also easy to clean. If there's oil or dust on the clips, just wipe them with a damp cloth and they'll be clean, there's no need to struggle to dig out the dirt in the crevices.

Metal Mop Clip has a particularly wide range of compatibility, if the clip of an old mop at home breaks, whether it's a wooden handle, an aluminum handle or a plastic handle, as long as the size is similar, it can be matched, there's no need to replace the entire mop just because of a small accessory, which is very cost-effective.

Our products are easy to operate. Both the elderly and children can change the drag heads by themselves without having to ask for help, the anti-slip teeth of the chuck are designed very considerately. They can firmly hold the drag head without biting the fabric, thus extending the service life of the drag head, all in all, it's particularly cost-effective.